For a great many artists, including those who specialise in pet portraits, stretching their own canvas not only saves money on commercially prepared canvases, but also provides them with a much better result. Generally, commercially prepared canvases are inclined to be rather light weight with only the minimum amount of primer required. When we prepare our own canvases we select the quality of canvas, stretcher bars and primer that suits our painting style, so creating something that will work perfectly with our finished painting and having a much improved chance of lasting in good order.

Step one
The most cost effective means to purchase good quality canvas is in bulk on a roll. Assuming this is what will be used, the first step is to cut off the amount of cloth needed. Do this by putting together the stretcher bars, then place the assembled frame on the canvas and draw a straight line approximately 40 mm wider than the frame on each side. This is based on using a standard stretcher bar that is about 15 mm deep, and gives sufficient canvas to fold over the stretcher bars but not so much that you have to cope with great folds of material at the corners. Cut the cloth roughly about 5 mm around the line (it will be trimmed down more carefully after the first application of primer).

Step two
Using your preferred primer (a universal primer is sufficient, providing a good key with good flexibility for both acrylics and oils), apply a single coat firstly to one side then, when that’s dry, the other side of the canvas. Be sure to take it right to the edge, covering the line previously drawn. Once both sides are dry, cut the canvas to the line, this will all help prevent the edges fraying. I also prefer to use pinking sheers for the final cut to help with this.

Step three
Canvas has a front and a back, insure you have the front (the side on which you will paint) face down on a level clean surface and place the assembled stretcher in it’s centre, so that there is 40 mm extra canvas on each side. Make certain that the back or ‘flat’ side of the stretcher frame faces up, with the ‘lipped’ side on the canvas. Commencing with one of the longer sides, fold the canvas over onto the reverse of the stretcher as tightly as possible, but making sure that the opposite side retains the 40 mm surplus. Pin or staple the canvas at the centre then, as you keep the canvas taught, approximately 40 mm from each end, leaving the corner free. When has been done, fix the canvas in between, so that there is a pin or staple just about every 30 – 50 mm.

Step four
Begining at the centre of the opposite side, use specialist canvas stretchers to pull the canvas over the bar. Whilst keeping this as tought as possible, pin or staple the centre point of the canvas, then 40 mm from either end, followed by points every 30-40 mm between. Now the canvas is fixed across the longest sides, the same can be done to the shorter sides, pulling as out as many wrinkles as possible.

Step five
At this point, all sides are fixed, the canvas is tight over the frame, with the corners still free. To fasten the corners, draw the centre point of the canvas corner over onto the rear of the frame, so that it is in line with the join (the point of the corner should face inward inline with the centre of the joint). Now turn up over one of the loose sides onto the corner, followed by the other side on top of that. As all these are held in place, use a single pin or staple to hold the folds in place (see attached photo). This then is repeated on each corner. When finished, put in the corner wedges to tighten the canvas further and remove any minor wrinkles.